The Galvanized wire gabion mesh is made of corrosion-resistant, wear-resistant, high-strength, low-carbon, high-galvanized steel wire or 5%-10% aluminum-zinc alloy coated steel wire, which is mechanically woven into a multi-stranded, hexagonal mesh. , the length of the twisted part of the double wire should not be less than 5cm, so as not to damage the protective coating of the steel wire. The editor of the Galvanized wire gabion below will introduce to you what the qualification standard of the Galvanized wire gabion is.

The Galvanized wire gabion is made of corrosion-resistant, wear-resistant, high-strength, low-carbon, high-galvanized steel wire or 5%-10% aluminum-zinc alloy coated steel wire. The length of the twisted part of the double wire should not be less than 5cm, so as not to damage the protective coating of the steel wire.

1. The wire diameter of the Galvanized wire gabion: The positive and negative values ​​should be controlled at 0.05mm, and this standard needs to be well controlled. The measured wire diameter is between 1.98-2.03mm, and within this data value is the Galvanized wire gabion net that is qualified.

2. The outcrops at both ends of the Galvanized wire gabion should not exceed 2mm, and the mesh diameter wire and weft wire of the Galvanized wire gabion should be strengthened.

3. The tensile strength of the Galvanized wire gabion should reach 120N, otherwise it will be regarded as unqualified.

4. Look at the surface: the mesh should be uniform, and the hot-dip galvanized layer should be uniform, so that the anti-corrosion effect can be ensured.